Cut the key to code.
Make a key for a lock.
The cylinder has pins and knowing the pin sizes the locksmith can make a key.
However the fact that it is relatively easy does not mean that it s a feasible solution for every lock type.
For those locks that do not have key codes or cars that the vin number does not work most locks can be rekeyed by taking the lock to a locksmith or having the locksmith make a house call.
The key does not have to be the one that is normally used with the lock.
When you remove the key from the lock hole you should see an impression left by the teeth of the lock hole in the exact placement of where you would like the teeth of your new key to be.
Slide the key blank gently into the lock hole.
You should then be able to push the tumbler out from the back.
To make a new key for an existing lock you cut a series of notches in the key so that it raises each of the upper pins just above the shear line.
Essentially you cut a pattern in the metal that matches the pattern of the pins in the lock.
Next you ll need a vise to secure the blank and a file to stroke out the grooves.
Insert the pins and reassemble the lock.
Now you ll insert the blank key inside and mark the dead center of the hole onto the blank key.
Do not lubricate either the blank or the lock hole when trying to push the blank into the lock.
Once the new pins are in reverse the steps to reassemble the lock.
Cutting the key to code might be the easiest way for a locksmith to make a key from a lock.
Doing so will ruin the impression.
Please note that the locksmith will charge you a fee for this.
To rekey the locksmith swaps the pins around.
The key number is stamped on the original keys provided with your lock.
If you do know the key number go to a locksmith or local hardware store to order keys.
A key code is a set of characters that is used to make a key for a specific lock.
Take off the end cam and inner spring then insert a key into the lock tumbler to push the pins away from the cylinder walls.
How can a locksmith make a key from a lock.
Dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to the color code on the special instruction sheet.